As a music lover, earphone closely connects with daily life, for this reason, summarize some small tequniques to optimize your earphone. Some of them are very easy to do, some of them need you to do some operation on your earphone. Of course whether do it or not depends on you. Note that if you change your headset, you will lose its warranty.25 Grounds Why You Should Preserve AAA cree flashlight Every Day

Break-in Headphones: a pair of new headphones lack the bass and the harsh voice lacks the focus. General Knowledge about your Sweet Digital Electronics This is because the electro-acoustic feature of drive unit is unstable. This Year, People all Love Video Games So it is strongly recommended that before you start to listen, burn with the bass music in continuous 24 to 48 hours. First listening to a few hours with a relatively low volume, then in medium – volume for a few hours, and then listening with large - volume in the remaining time. Break - in can improve the mechanical properties of the suspension system in the drive unit, and can make the coil wounding more tightly. For some headphones, such change can be quite large.

The earphone wears the position : This very easy to do, but did you try to adjust your earphone's optimum position? For many headphones, sound field and sound balance is very strongly depends on the location of headphone drive unit. Science studies have found that when the drive unit relative to the position of the ear entrance moves lowly forward, the sense of depth will be enhanced.

Impedance optimization: the output of the earphone of the power magnifier usually connects directly with the louderspeaker. Resistances with resistivities from 200 ohms to 600 ohms are cascaded to avoid the damage to the earphone and AV. For the other aspect, the earphones of radios and CD players are usually driven by chips. They differ from the output impedances( less than 50ohm ). Generally, the impedance of the earphone is highest at low frequency. For most of the earphones, increasing the output of the impedance can make the sound more dim and mix. Therefore, if your earphone sound is shrill, you may consider increasing the effective output impedance of earphone jack. The simplest method is to add a conversion between earphone and earphone jack.

Acoustic and mechanical damping: In addition to well-designed earphones, most closed-end earphones have a heavier sound pollution than open-end earphones. In particular, cheap earphones are usually without any sound-absorbing damping material, so put a small piece of sponge into the earphones can effectively reduce sound wave

Change Line: Have you ever compared the diameter of your headphone cable structure and the really high-quality wire rod? If you have a comparison, there is some doubts the voice of your headphone cable. The earphone wire is always optimized for the comfortability( the weight, mechanican strength, flexibility, non-transmissive machinery noise. Normally the quality of those wires' pure voice is very bad. Of course, the comfortablity is the most important, if you do not care about the comfortablity, changing the wire will have very good return. These techniques are certainly not complete, and don`t guarantee to surly improve the sound quality. But it is still worthy of trying.